dbkb0227 Posted November 16, 2014 Share Posted November 16, 2014 Hello Everybody! I created and elevation and put notes and dimensions on as needed. I saved and closed the elevation. When I reopened it, all the notes and dims are there but the house front elevation is not. If I create a new front elevation, the house shows up in that one. Any idea why this would be happening? Thanks for the help! Link to comment Share on other sites More sharing options...
DavidJPotter Posted November 16, 2014 Share Posted November 16, 2014 If you used a back-clipped cross section or elevation camera you might have moved the saved camera icon for that view beyond the back-clip plane, thus making anything beyond that back-clip point invisible. It could be layers turned off for that camera view type (check and see). It will be one or the other I think. DJP Link to comment Share on other sites More sharing options...
dbkb0227 Posted November 16, 2014 Author Share Posted November 16, 2014 This is what happened. When I went to send the completed elevation to a layout, I got an error message and it closed down chief architect. When I reopened chief, the elevation was gone so I created another one of the same view. When I was done with that one, I saved and closed it, just to test it before sending it to the layout. When I reopened it, the notes and dims were there, but not the elevation. I sent to a layout just to see what would happen. Only a partial elevation showed up with the notes and dims. When I have the elevation open, event though I cannot see the elevation, I can click on where its suppose to be and it will "high light" but not show up. Link to comment Share on other sites More sharing options...
DRAWZILLA Posted November 17, 2014 Share Posted November 17, 2014 Could also be a video card problem, what kind of video card do you use? Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now