Why does wall sit outside mono slab?

[DOPSuppliers]

The OK pic is from an AS Built I did and the Problem pic is from the same, but saved as proposed plan and I can not figure out what I did that is different and why it changed.  I have never seen this.

OK Footer.pdf

Problem Footer.pdf

3D.pdf

Edited April 24, 2020 by DOPSuppliers
Add pic

[DOPSuppliers]

Eric, I don't believe I know how to do that ...

[parkwest]

Just drag the image to the text box on here.

[joey_martin]

The front wall may have the main layer reversed or set up wrong. Look like the inside of the wall is marked as the "to foundation" layer. Or, you have an offending invisible attic wall throwing everything off.

 

[DOPSuppliers]

Joey Martin, thanks so very much for your assistance!  It wasn't one of your ideas, but while checking on those, I noticed a box checked on the structure tab that should not have been that I hadn't seen during the other "100" times I went through those details.

Thanks again,

[CharlesVolz]

So the answer is . . . ? Rebuild foundation?

 

[DOPSuppliers]

Charles, I found I had somehow checked the box - Stop wall at floor below, in the structure tab of the wall specs on that particular wall only. I looked for inconsistencies numerous times without seeing that.