A few wall height and other frustrations for an otherwise beautiful spring day.

[EconBlueprints]

 I have a few things to finish up on the plan before I do the final elevations and story pole dimensions, but I have some issues that are difficult for me to solve.  The plan is attached, and the issues are noted in each of the four elevation views (floor plan dimensioned 1st floor).
In short, for some reason the garage walls have a thin first course of siding, and other walls have a full width siding starter course.  Some foundation walls show 9'2" and I figure out where that comes from. 

Then a roof return issue and a porch post issue.  In the front elevation, I get a roof return on one side, no return on the other.
I would like to move the porch post a an inch or so to the right, and to the rear but only this one post.

DeMuro_Ranch_Plan.plan

[Mark3D]

some of your problems skinny sidding at bottom adjust pattern vertical  offset, Eaves hanging below facia check your structure tab of roof plains faica is to small 

[ShaneK]

Delete roof plan and make new will fix overhang, go to floor defaults and make it 109 1/2" on floor 0 and delete existing elevations and make new. I did all this in X11 or I would post plan.

[EconBlueprints]

Thanks, that gets me about 95% there!  I can fake the other 5%.

 

 

[Mark3D]

hear is the file with some of those issues fixed i tried yesterday to post the reply but must have missed a step and it never happened

DeMuro_Ranch_Plan.plan

[Mark3D]

Just for a bit more info i  fixed those small triangles in the sidding by turning off Sil plate in the wall foundation tab and adjust the default wall heights in the structure tab