Rounded Wall Corner

[Rich_Winsor]

Seems easy enough but I haven't been able to make it happen.

I don't need a curved wall. I need a curved corner on the 90°

intersection of 2 straight walls. I can achieve the effect using a

molding polyline but then it doesn't behave as a wall. I tried a

vertical quarter round molding at the intersection but the walls

snap together at the corner and override the molding section.

 

Any thoughts?

 

 

[Chopsaw]

Rich, Any possibility this would work for you?

[dshall]

Rich, Any possibility this would work for you?

Ok Chop, how did you do it?. 3 walls? Is it easy to control the radius?

It looks like too large of a diameter to be a true bullnose corner.

[Chopsaw]

Hi Scott,  Yes three walls with the radius created by a "Curved Exterior Wall"    cranked around as tight as it will go to form a 90^o corner. Not too difficult. I take that back as Chief just locked up on me after posting.  Tech will be really happy to hear from me again.

 

Chopsaw

[Rich_Winsor]

Yeah, I had a play with the three wall approach. The catch is

that you can't get a tight enough radius unless you use a very

thin wall. This, of course, leads directly to the 5 wall approach.

 

BTW, for some reason that curved wall section really slows

down my machine too. Didn't crash it though.

[Chopsaw]

Rich,  I was able to get a sharp inside 90 with a  6" wall after I posted the first pic. I you want to look at the plan I can post for you. It is just a matter of finding the correct handle.  And Oh I think I crashed because I had 2 plans open and the other had already maxed out my video card.