Migaloo

I will check this out. Thank you

I have drawn a project with a flared roof but I cannot find a way to make the two planes join without the joint line showing between them. Is there a way to eliminate this line in the elevation views of the project after they are sent to the layout? ROCKY GRANT.pdf

I figured it out. Thanks

How do I prevent all the work I've done on the foundation plan from being deleted when I build the foundation again?

Thank you sir I will try this.

Okay here you go. siding issue plan.zip

It says its to large to attach.

Not sure what is causing this issue. I have the sidingt set to extend 12" but in a couple places it does not extend but the house wrap and OSB does. Any advice would be appreciated.

I got it to build changing room type to balcony and then back to deck. ???

Having an issue getting my deck framing to generate under my deck.CHIEF QUESTION DECKS.zip

Okay thank you.

Well, I can go up and down through the levels. Foundation = 0 , First floor = 1, Second floor = 2, Attic = 3

I have a bonus room above the garage. When I go to the floor overview camera it does not open the roof up. The roof stays in place so that the view of the bonus room is blocked. Is this normal? or is their something else I need to do?

I applied this to the front porch wall. I do not see a way to change the height or depth of the brick veneer.

It appears that the program forces it to be a foundation wall which does not allow you to change the height of the wall. Here is the result.