-
Posts
733 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Posts posted by dskogg
-
-
doesnt show in standard view, but you would not expect it to in that view as this does not show edges in that view type.
-
-
I did some details and when i went back to copy these to add to another plan all the hatching including
the arrows were all individual lines?
I understand that if you produced a cadd detail from view you would get this but these details were produced
manually in cadd.
Anybody run into this before?
-
I am actually printing to printer.. having a hard time making the line weights print out properly
-
I am struggling with getting my line weights to show proper for 3/4 and 1" scales.
So i understand there are a number of factors.
- line weight number
- drawing sheet print setup
- scaled view
- layout sheet print setup
What do people use for section lines in details as far as line weight?
What should i have my drawing sheet set to?
What should i have my layout line weight set to?
I have tried a number of combinations but the view on the screen is so much thicker than what i get in print.
-
-
I was sure that i could pull markers away to not have text overlap each other, has this changed?
I do not know how to do this. CA automatically did this for the 4" dimension but fails to do this for the 10" dimension.
Anyone know how to do this? I called ca and they said that they did not know and to do it manually.
-
Thanks for looking at this, much appreciated, it is good to get help from the forum.
-
-
thanks Mick, i want the room height to stay the same just raise roof, in a sample plan it was raising walls and building them as attic walls, but my plan would not do this?
i have auto build attic walls checked still didnt work.
-
i am sending my plan in to ca to look at, i managed to get walls to rebuild automatically with a sample plan now...not sure whats going on.
-
I dont want to edit all roof planes, just my upper roof.
I am not quite sure I understand how this roof is supposed to work but i remember ca used to rebuild
walls when roof planes were raised?
I just wanted to move upper roof up so lower roof would slide under without having to manually pull up walls, easy enough to pull up walls but then
i find too many times all this manual manipulation causes all kind of issues.
-
I used the transform/replicate to move roof up but walls dont come with roof.
Where is the roof planes dialogue vs roof plane?
-
-
Hi Eric, so the only way to raise roof is to do this before you build it? Because this option is not available after roof has been built?
What if i had a very complex roof that was manually drawn, i have to redo roofs to raise them?
-
-
plan shows 2600 the zip file shows 0
-
I am not sure what i am doing wrong?
-
see if this works
-
-
Here is a sample plan where i raised roof off plates 10" and the walls fail to raise to meet
the soffit?
How would one make a roof with a high heel if the walls dont raise?
Am i missing something?
-
-
-
Physically Based Rendering
in General Q & A
Posted
Not sure how you guys are getting this physically based render to work, here are two renders one physical and one standard.
The physical is very dark and bad. Does a good job on stainless steel, am i missing something?
I even have the enhanced lighting turned on?