Half wall in opening

[builtright3]

I would like to put a half wall in this opening. Anyone know how to achive this without having to do a pass through window and a doorway?

 

[PitMan71]

Use two doorways beside one another set the opening/half wall the height and distance off the floor that you need and use the mull tool to mull them.

[Joe_Carrick]

create the half wall "out of plane", no room definition and then move it into placein the opening.

[builtright3]

1 hour ago, PitMan71 said:

Use two doorways beside one another set the opening/half wall the height and distance off the floor that you need and use the mull tool to mull them.

 

43 minutes ago, Joe_Carrick said:

create the half wall "out of plane", no room definition and then move it into placein the opening.

I tried both ideas, thank you!

The half wall doesnt include the base mouling so I'm guessing I just have to put that in manually

The mulled unit leaves a post between the two unless Im doing something wrong

 

Edited yesterday at 02:45 PM by builtright3

[builtright3]

This is interesting.

I didn't mull the openings together on this one. I simply overlapped the window opening over the door opening using the Ctrl key, and it came out perfect!

 

[builtright3]

 

The header height works better if Im using to doors rather than a window and a door

 

 

[builtright3]

1 hour ago, Joe_Carrick said:

create the half wall "out of plane", no room definition and then move it into placein the opening.

 

1 hour ago, Joe_Carrick said:

create the half wall "out of plane", no room definition and then move it into placein the opening.

Thank you guy's foor your help. Finish came out great!

[PitMan71]

4 hours ago, builtright3 said:

Thank you guy's foor your help. Finish came out great!

looks great! Well done.