Brick quoins: can I reverse which sections stick out and which are flat?

[wkshank]

Setting the bottom of course just moves where the quoins begin, but the "outie" sections stay where they are.  I need the bit at the frieze NOT to have a quoin sticking out, and the way it's generating is exactly opposite of what I need (need 3 bricks out, then 3 bricks in, but it's doing the reverse order vertically).  Workaround?  A setting I can't find?

[DBCooper]

Did you try setting "swap start block"?

 

[wkshank]

Swap only works if you're alternating large and small blocks... maybe I'll try doing that, and set the small one at zero thickness with zero space between ??

[wkshank]

oops nope, can't set more than one thickness.  : (

[glennw]

I am not sure if this helps or not.

I used a Corner Board with a Quoin on top.

 

 

[DBCooper]

If Glenn's solution doesn't work for you, you should post a picture of what you are trying to do.