Ramp Sink (Sloped Sink) Application

[Drew-PRH]

Good day,

 

Has anyone applied a ramp sink (sloped sink) to any of their Chief designs?

 

If so, where did you find it from a library if there is one?

 

Here are few Undermount photos.

 

We have a company here in Bend Oregon (Cement Elegance) which manufactures counter and sink as one integrated unit, which is fine.

 

I happen to be looking in the undermount direction at this time, not the integrated as one.

 

Any suggestions would be appreciated.

 

Thank you - Drew

[rgardner]

41 minutes ago, Drew-PRH said:

Good day,

 

Has anyone applied a ramp sink (sloped sink) to any of their Chief designs?

 

If so, where did you find it from a library if there is one?

 

Here are few Undermount photos.

 

We have a company here in Bend Oregon (Cement Elegance) which manufactures counter and sink as one integrated unit, which is fine.

 

I happen to be looking in the undermount direction at this time, not the integrated as one.

 

Any suggestions would be appreciated.

 

Thank you - Drew

https://www.chiefarchitect.com/videos/watch/6201/accessible-bathroom-counter-with-integrated-sinks.html

[Kbird1]

You can make it out of Solids , ie make a block and then subtract the slope from it with another block the shape of the slope.

 

This one is a vessel sink but same principle........

 

 

 

https://www.chiefarchitect.com/support/article/KB-00761/modeling-custom-3d-objects.html

 

https://www.chiefarchitect.com/support/article/KB-02925/using-3d-polyline-solids.html

[Drew-PRH]

Thank you so much!

 

That looks pretty easy.  I was just not using the proper search terms as well as not knowing the direction of search.

 

Good job rgardner and Kbird1 (Mick).  Great information!

 

Thanks again - Drew