mdavisdcb Posted June 28, 2022 Share Posted June 28, 2022 Good Morning, I am having some staircase issues. This L shaped staircase is leading from the interior of the home to the above garage loft. The stairwell will cut into the garage so I need a way of putting a full wall on the angled part of the stairwell leading upstairs. Is there a simple way to do this? Thank you, Mitchell Davis Running on CA Premier X13 Link to comment Share on other sites More sharing options...
rgardner Posted June 28, 2022 Share Posted June 28, 2022 9 minutes ago, solver said: Draw wall, drag bottom up in elevation. Alternative is to place a ceiling plane parallel under the stairs and have the wall be set to cut wall at roof in the roof panel of the wall dbx. Link to comment Share on other sites More sharing options...
mdavisdcb Posted June 28, 2022 Author Share Posted June 28, 2022 Thank you both for answering this for me. M. Davis Running Chief Architect Premier X13 Link to comment Share on other sites More sharing options...
OldBarnDesign Posted July 1, 2022 Share Posted July 1, 2022 Creating a wall and raising the bottom helped me pull this off as well! It took a lot of manual tweaking though. I'm still not a snaps expert. Link to comment Share on other sites More sharing options...
OldBarnDesign Posted July 2, 2022 Share Posted July 2, 2022 Thank you sir, that explanation helped a lot! I can't wait to try it. Cody Link to comment Share on other sites More sharing options...
Thewoodmaster Posted July 19, 2022 Share Posted July 19, 2022 On 6/28/2022 at 10:32 AM, rgardner said: Alternative is to place a ceiling plane parallel under the stairs and have the wall be set to cut wall at roof in the roof panel of the wall dbx. I still can't get this to work on any of my drawings, when I try your suggestion my ceiling plane auto snaps to a location inside the drywall of the wall it's cutting and it isn't clean. Is there a way to force the ceiling plane not to snap to something? Link to comment Share on other sites More sharing options...
rgardner Posted July 19, 2022 Share Posted July 19, 2022 19 minutes ago, Thewoodmaster said: I still can't get this to work on any of my drawings, when I try your suggestion my ceiling plane auto snaps to a location inside the drywall of the wall it's cutting and it isn't clean. Is there a way to force the ceiling plane not to snap to something? Every circumstance is different. Sometimes it will not work depending on the walls around it and room size, etc. You can use an invisible wall set to Non Room defining & PARTITION WALL that is placed so the middle of this invisible wall is at the outside layer of the wall you want to cut. This will allow the ceiling plane to snap to the middle of the new invisible wall. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now