JimB204 Posted January 7, 2022 Share Posted January 7, 2022 I am running into a problem I have never had before. When I go to send my 2 floor plan to layout, I can't send just the first floor or just the second floor, whichever one I send the other floor shows up with red lines on top of the floor I want. I've attached a screenshot to show what is happening. I am trying to send both floors to layout, separately, so that I can show both floors on one layout page. I have done this successfully in the past (last week) but cannot figure out where I am going wrong. I've tried saving the plan in different plan views and nothing is fixing it. Any advice would be appreciated! Link to comment Share on other sites More sharing options...
Chopsaw Posted January 7, 2022 Share Posted January 7, 2022 Red is usually used for a reference layer. Open up the DBX for the Layout Box Specification under the Plan View tab and turn off the Reference Display. Link to comment Share on other sites More sharing options...
joey_martin Posted January 7, 2022 Share Posted January 7, 2022 If you are new to X13 you are sending a SAVED PLAN VIEW most likely and that SPV was created with the reference layer on. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now