auto build framing Floor and Ceiling Framing not generating in X12

[gravattedesign]

 I have difficulty troubleshooting WHY my ceilings and floor framing isn't generating when Auto Build Framing is run. I have checked all the room default settings as well as the framing default settings and all seem to be set correctly for my project (2x10 floors, 2x6 ceiling). The plan file I am working with was purchased from a Designer who worked on the house several years ago and assembled the As-Built model. That said, This is a recent situation with the framing. a week ago Auto Build Framing worked fine.  What may I be overlooking?

 

 

One other note: this issue appears to only happen where the Second floor exists. Main floor rooms with just attic space above, DO generate ceiling and floor framing.

 

 

Edited November 24, 2021 by gravattedesign
added comment

[robdyck]

12 minutes ago, gravattedesign said:

What may I be overlooking?

Posting the plan. That would eliminate guessing.

[gravattedesign]

[Dermot]

By "post the plan", I think he means post the actual .plan file, not a picture of the floor plan.

 

You might want to check out this tech support article first though:

https://www.chiefarchitect.com/support/article/KB-00400/troubleshooting-why-floor-and-ceiling-framing-doesn-t-generate.html

 

[gravattedesign]

Thank you Gentlemen for the guidance. The *.Plan file is too big to post  @ 26 mb.

[Dermot]

Did you try the tech article?  Did it help?

 

You can always try putting the plan file in a compressed folder which should make it small enough to post.

 

[robdyck]

18 hours ago, gravattedesign said:

Thank you Gentlemen for the guidance. The *.Plan file is too big to post  @ 26 mb.

Zip it up, or use dropbox or something similar. I've got a bit of time to take a look this morning...

[gravattedesign]

Zipped reference ZIP file for review. 

https://drive.google.com/file/d/1TN2wNeCK0Q7MxfRs447eDpB063Y12nn4/view?usp=sharing