How To Show An Elevator Cab In 3D


agenoarch
 Share

Recommended Posts

Commonly I just make a series of "open Below" rooms that line up, floor to floor. On each floor I place a sliding door with appropriate trim. This serves fine in plan views.

If you require a cross section then you can carefully add the cab as 2D CAD overlays on the cross section. I have never been asked to model an elevatior with the doors open and I suppose the quality of rendering would dictate how much detai needed to be added as poly-line solids, molding poly-lines etc. One can get quite fancy and detailed at need.

 

DJP

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share