Michael_Lewis Posted November 18, 2017 Share Posted November 18, 2017 Need Help. Created a new molding but cant manipulate it. I created a soldier course molding and really like the way it works except i can Miter the ends or trim or even bring another layer to the front to cover it.. When you open the plan pull up the front elevation and youll see what im talking about. Ideas Please??? Lot 8 Brock Village.plan Link to comment Share on other sites More sharing options...
Michael_Lewis Posted November 18, 2017 Author Share Posted November 18, 2017 Thank you Link to comment Share on other sites More sharing options...
Michael_Lewis Posted November 18, 2017 Author Share Posted November 18, 2017 Why would a room divider not connect properly to a wall. Same plan as above. trying to separate the kitchen, dining and living rooms. I have actually moved exterior step out wall as well to try to accommodate a proper connection and still not working. Screen Shot included too. Link to comment Share on other sites More sharing options...
Kbird1 Posted November 18, 2017 Share Posted November 18, 2017 1 hour ago, Michael_Lewis said: Why would a room divider not connect properly to a wall. Same plan as above. trying to separate the kitchen, dining and living rooms. I have actually moved exterior step out wall as well to try to accommodate a proper connection and still not working. Screen Shot included too. Are you sure it is a connection issue and not an Off angle issue with the 1/2 wall? click the yellow triangle it should tell you.... here are a couple of possible fixes for the missing drywall on the end of the full wall where the 1/2 wall meets it too.... Link to comment Share on other sites More sharing options...
Michael_Lewis Posted November 18, 2017 Author Share Posted November 18, 2017 This is all that happens when i click on the triangle Link to comment Share on other sites More sharing options...
Michael_Lewis Posted November 18, 2017 Author Share Posted November 18, 2017 I opened the pony wall and the thickness was set a 0. Not sure how that happened. I reset it at 4 1/2" and with a little repositioning everything fell into place. Thanks guys... Link to comment Share on other sites More sharing options...
Kbird1 Posted November 18, 2017 Share Posted November 18, 2017 that is strange.....it shows as a normal width wall .....good find Link to comment Share on other sites More sharing options...
Alaskan_Son Posted November 18, 2017 Share Posted November 18, 2017 18 minutes ago, Kbird1 said: that is strange.....it shows as a normal width wall That's because its a pony wall with the main (upper) wall type set to be a room divider but with the lower set to be displayed in plan views... ...Its just doing as it was told. I think you're probably making that spot a lot more complicated than it needs to be. There are other ways as well but maybe try something like this instead. It's probably the quickest and easiest... Railing Fix.plan Link to comment Share on other sites More sharing options...
Kbird1 Posted November 18, 2017 Share Posted November 18, 2017 Ahhhhh good find , I have never seen a 1/2 wall setup that way so I never dug that deep ....... I now see he did say it was a Ponywall ( common term here) but I didn't think he had made one in CA for it, normally I just set Railing , then solid then set the newel height to the wall height needed. M. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now