Dennis_Gavin Posted July 27, 2016 Share Posted July 27, 2016 Attaches is an opening and a pass through set to no frame and blocked to create an opening with a half wall with a jamb and casing all around. So far so good until I select arch for the top. THen I lose the half wall, I can do a no locate railing and drag into place but then I don;t get the fully cased opening without a lot of manual editing. Any suggestions for how to do this without a lot of manual work? Link to comment Share on other sites More sharing options...
DRAWZILLA Posted July 27, 2016 Share Posted July 27, 2016 Make an opening for the whole opening and throw a 1/2 wall with no room def. and slide it in place. You may need to add the base manually though. Link to comment Share on other sites More sharing options...
Dennis_Gavin Posted July 31, 2016 Author Share Posted July 31, 2016 OK, getting closer. Added an arched pass through over the mulled unit and it works except for a thin white line. Can't figure out how to get rid of it. I zeroed out the frame/jamb and unchecked has jamb but still get a thin white line. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now