Dennis_Gavin

how to arch opening with half wall

Recommended Posts

Attaches is an opening and a pass through set to no frame and blocked to create an opening with a half wall with a jamb and casing all around.  So far so good until I select arch for the top.  THen I lose the half wall,  I can do a no locate railing and drag into place but then I don;t get the fully cased opening without a lot of manual editing. Any suggestions for how to do this without a lot of manual work?

post-132-0-26893800-1469621820_thumb.jpg

Share this post


Link to post
Share on other sites

Make an opening for the whole opening and throw a 1/2 wall with no room def. and slide it in place. You may need to add the base manually though.

Share this post


Link to post
Share on other sites

OK, getting closer.  Added an arched pass through over the mulled unit and it works except for

a thin white line.  Can't figure out how to get rid of it.  I zeroed out the frame/jamb and unchecked has jamb

but still get a thin white line.

post-132-0-29422000-1469978998_thumb.jpg

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now

  • Member Statistics

    27478
    Total Members
    6254
    Most Online
    Oilersfan20
    Newest Member
    Oilersfan20
    Joined