Adam_Gibson
-
Posts
553 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Posts posted by Adam_Gibson
-
-
16 hours ago, solver said:
Looks good -- how did you do it?
I followed your instructions! Although, I couldn't figure out the part about a point marking the radius and using the Transform/Replicate to copy and rotate the p-solid about the point. I thought I had a good handle on that tool, but apparently not. Thank you so much!
-
Thanks so much for your help. This is the idea I had in the middle of the night, and now I'm able to show my client, thanks to you!
-
You're too kind. Thanks, Eric!
-
I've got it! But Eric, I like the way yours looks better. Would you mind posting the plan? If not, I understand. Thanks so much!
-
1
-
-
Thanks, Eric! I'm going to try today. I really appreciate this!
-
29 minutes ago, solver said:
These are molding polylines. I used a square edged molding, but they could have a edge profile.
Eric, would you mind explaining your steps? I'm having a difficult time getting molding lines to generate in elevation view, which is where I assume you did this? Please?
-
Yes, exactly!
-
There's also https://www.sketchuptextureclub.com/ and https://www.textures.com/ to modify about anything. I've found some useful, realistic textures in both places.
-
1
-
-
Although the molding will only be 1/2" thick, I assume what I'm attempting is to coffer a barrel ceiling. I've tried with ceiling planes and with polyline solid. I prefer the look of the p solid because the arch can be much more fluid if I break the arch (see close up of yucky barrel just below the more fluid one). Either way, I can't figure out how to apply molding to either so it matches the arch. Heck, I wish I could just apply cabinet doors to form the arch. Any suggestions would be much appreciated.
-
Most Welcome.
-
Thank you!
-
When I opened the Layer Set Options on the RCP in Layout, it shows Layer Set 38. It could be that each time you've sent to Layout you've made a copy of the Active Layout Set, rather than sending the Default Set. See graphic.
-
-
Wow. I will do that!
-
Wow. I will do that!
-
You mean rather than running cables to an SSD, I'd actually purchase an m.2 drive, plug it into a PCIe slot, clone it, and have a faster system?
-
Asus PRIME H370M-PLUS/CSM LGA1151/ Intel. Does this sound right?
-
Which means nothing to me. Next time, I'll be asking for advice.
-
To be clear, I didn't build my system. I will next time. Asus PRIME H370M-PLUS/CSM LGA1151/ Intel
-
The PDFs don't help. I'd need to see the CA files.
-
Maybe I can help if you post the plan and layout.
-
Amen to that!
-
And why are you up so early?
-
Scott, those seem like bare minimum requirements.
Molding on Barrel Ceiling
in General Q & A
Posted
I see! That's a much better method. I simply did it manually. Once I'd done the left half I copied and reflected about the center object. My method would have resulted in hair pulling if there'd been more than a couple of p-solids to manipulate. Thanks again for the lesson!