JKEdmo Posted December 1 Share Posted December 1 I was revising some manual roof planes today from 2x8 to 2x12 structure... I noticed most of the roof planes maintained their plate heights with the roof structure / thickness adjusting upwards. This is what I'm used to. But, I noticed a few roof planes adjusted downwards, i.e. top of rafter elevations stayed put and the plate heights dropped. I was wondering what determines this behavior? Thanks again, Jim Link to comment Share on other sites More sharing options...
mtldesigns Posted December 2 Share Posted December 2 4 hours ago, JKEdmo said: few roof planes adjusted downwards, i.e. top of rafter elevations stayed put and the plate heights dropped. Were these over areas that didn't have a ceiling heights? Guessing here.. Link to comment Share on other sites More sharing options...
JKEdmo Posted December 2 Author Share Posted December 2 14 hours ago, mtldesigns said: Were these over areas that didn't have a ceiling heights? Guessing here.. No, they had rooms below. A mystery to me! Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now