Floor truss auto built beyond foundation

[SHCanada2]

I have a cantilever, but when CA frames it. the Floor truss inside the cantilever extends beyond the cantilever wall, and thus ends up partially off the edge of the outside of the foundation wall

It is highlighted in blue

 

694 Muirfield Cr - fe (4).zipFetching info...

other than deleting it and then causing auto to run off, any other way?

[Garybills]

Try marking the little room that was formed between the two walls as unfinished instead of open below. Then rebuild the floor framing, it also draws in the rim joist that was missing.

 

[SHCanada2]

that worked! thanks.

 

...Although I think CA should be smart enough not to build framing outside of exterior walls...

 

 

[Garybills]

  On 7/22/2023 at 5:37 PM, SHCanada2 said:

that worked! thanks.

 

...Although I think CA should be smart enough not to build framing outside of exterior walls...

 

 

Expand  

It was strange how it built the truss there!!!! I just stumbled into the little room, I was about to give up when I deleted the inside wall in the stairwell and the render changed to a rim joist instead of the floor truss. 

[SHCanada2]

  On 7/22/2023 at 7:18 PM, Garybills said:

It was strange how it built the truss there!!!! I just stumbled into the little room, I was about to give up when I deleted the inside wall in the stairwell and the render changed to a rim joist instead of the floor truss. 

Expand  

in case anyone is wondering why the little room is there. ..below is a 8" concrete foundation, so the wall had to be offset