Walkthroughs

[chief58]

I am trying to do a walkthrough with no success, I have my settings at 30 frames per sec. and 18 along path, recording seems ok but on the playback it is like I am in a jet plane going through the house any suggestions 

[AlwaysEastern]

Try changing the "speed after" setting for each camera in the walkthrough path specification box. You must highlight each camera while in the spec. box to see its settings - then you can modify accordingly. I have had good results with 1.5, 2, 3 second speeds.

[chief58]

Brian the 1.5, 2, 3 second speed are you putting those # in where it says speed after or duration

[Electromen]

Lengthen the overall duration.

[AlwaysEastern]

Brian the 1.5, 2, 3 second speed are you putting those # in where it says speed after or duration

Hey Raymond, you can do it either way. I only use the duration setting to get an overall speed. Then each camera should be individually adjusted. When each camera pans/tilts/ etc., during the walk through, it's perspective changes making the viewer see some portions of the walkthrough too quickly. The best way to demonstrate this is if you were to have two cameras set with the same settings as a comparison: one going straight through the center of a large room and one camera turning through a narrow hallway. The latter is going to show the space faster. Then if you reduce the "speed after" setting of the camera that is turning, you will see that it will appear to match the first.