Freize Boards

[sdpatt]

Within the attached plan, second story I have placed a gable roof over the entry section. I am attempting to add a freaze board under the eves/gables. I am selecting from the Chief exterior options/freize boards but have been unsuccessful in getting them to show up in the 3d perspective overview view? Any suggestions?

Casa Maravilla AAAA Roof.plan

[Mark3D]

what version of chief are you using its good to put that into chief talk signature so people can fix problem and send the file back to you and you, will be able to open it if there version is correct

[sdpatt]

Yes, sorry its version 6

[Mark3D]

I had a go at your freeze problem and got it working in x 10  but was a bit tricky I would give your wall asbuilt layer like bricks and render so yo can see if they are facing the right way as they are mixed up because the were not drawn clock wise , also those complicate walls on the lower story are giving chief a hard time to start with I would delete some of them and replace with soffits so the walls are smooth from lower to first floor also I think it helps if you give the roof a bit more over hang like 14 “ 

i have all my previse versions of chief but are missing my key code to x6 so can’t send  a file with it working

 

you may be better getting that bit working with molding lines and just push on with rest of your roof as it is tricky to trouble shoot 

[sdpatt]

thank you I'll give it a try. Interestingly, there is a single story garage (first floor). I tried the freize boards on that building and they took immediatly.