Migaloo

I tried that too. I just drew a cad circle and noticed that it has an x in the middle of the circle that I cannot select to delete. Strange stuff here.

I can't select them. I selected the anchor straight out of the library and this is how they appear. Also my cad blocks with the anchors in them have the X marks on them also. Can't get rid of them.

What is making these X marks on this anchor bolt? How do I get them off?

Maybe I should ask a different question: In this plan I am attempting to show the brick ledge extending below the lowest floor level. As the front of the house is elevated for steps up to porch area and the rear porch is16" lower as it steps out of the sunken living room. I have been playing around with the stem wall trying to make this happen so that in my elevation views the brick exterior will extend below the floor level in order to cover the areas not covered by the terrain. I hope I have made sense here. I think maybe there is a better way to do this than what I have done.

ok I will play around with it some more. I think I will try rebuilding them first. Thank you for you advice.

Anyone know what the issue might be?

Ok I think I did it. allentana.plan

I understand. Not sure how to attach the plan?

I have an issue with the foundation views of the same foundation wall not being the same. The garage view has more layers in the view. It appears to show footing and brick layer. The house view only shows outer wall and inner footing layer. I have been unable to see any difference in the settings that might cause this. The wall is a 8" concrete stem wall 4" brick ledge. Any ideas what is happening here?

Thank you rosco2017. Not sure how it got assigned to that room specifically but that's what the issue was.

I can't figure out what is making this band around this room. The floor is sunken 12" from rest of house. No moldings are turned on. Can't select the line individually but you can use the eyedropper to change the material finish. Any thoughts?

Ok. Thank you for all of your help.

Well so much for the thumbnail... the circles do not appear on the exported image?? very curious....

I just upgraded to Chief from Pro and opened a floor plan that I have been working on. It has 3 Shaded Circles on floor plan that I cannot select or otherwise do anything with? I am not sure what they mean or how to get rid of them. Any suggestions?