nick66 Posted November 3, 2015 Share Posted November 3, 2015 When creating my foundation I'm wanting it to automatically align1/2 an inch past the main framing layer for my OSB sheathing to sit on. I've tried creating half-inch layer in my foundation wall defaults. Below the concrete description there's an option for an offset. Is this where you can change it? If So I must be doing it wrong. Link to comment Share on other sites More sharing options...
glennw Posted November 3, 2015 Share Posted November 3, 2015 In the wall Type Definitions dbx, use Foundation to Exterior Of Layer to point to your OSB sheeting. You can further offset the foundation out past the wall by using a negative value for Foundation Offset. Link to comment Share on other sites More sharing options...
nick66 Posted November 3, 2015 Author Share Posted November 3, 2015 Nevermind I figured it out. You have to go into your exterior wall defaults and select which layer the foundation is to build to Link to comment Share on other sites More sharing options...
nick66 Posted November 3, 2015 Author Share Posted November 3, 2015 Thanks for the tip. Glenn Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now