aligning top plates with different rafter depths

[chrisinnh]

Back again!  Going to be a habit, working on a Passive House retrofit.

 

Half of a 1986 saltbox will be converted to a clerestory with tji rafters, the other half will get a second set of 2x10 rafters overlaying the existing.

 

When I split the roof planes between clerestory and saltbox, and change the clerestory rafters to 18in tji rafters, Chief drops the top plates.  How do I keep the plates at a constant height?  The roof overlay on the second half of the roof will match the height.

[SHCanada2]

I assume these must be edited or manual roof plans?

 

did you try and move the roof plane in the Z direction using transform replicate?

[chrisinnh]

Yes... edited.  I haven't tried the Z plane as that would involve moving the roof structure and adjusting all of the walls, correct? I was hoping to lock the plate somehow.   

[SHCanada2]

assuming the room structure has the top plate set correctly, I think will merely move the roof structure up. i do this quite a bit for teusses

 

Edited Saturday at 03:02 PM by SHCanada2

[chrisinnh]

Does the trick, nearly!  I plugged in different values until the bottom of the rafters aligned with the top plates.  But, I assume, the accurate value is the difference in plumb cuts between the two rafter dimensions? 

 

Framing and elevation camera views attached.  The elevation and framing views don't agree.  Two issues: elevation view isn't repopulating to reflect framing; elevation view shows proper rafter tails while framing view does not.

Edited 17 hours ago by chrisinnh

[SHCanada2]

Looks like you may not be showing the corresponding layer. Try switching to the all layers layerset to see 8f the elevation shows correctly