Need help with using ramp for sloped floor

[Evolution]

 

The more I work on this plan the more issues pop up.   After finally getting the ramp in place, by first lowering the floor in the existing and expansion floor of the sanctuary I had to stop and fix a dozen different little issues and I don't have a clue what caused them. Now I'm back to working on the sloped floor (using the ramp tool). I have the ramp in place now, but I can't get it to cut into the two areas on each side of the rear wall at the HVAC chases.   The break tool and the 3 key, neither one allow me to break the end of the ramp and pull it back into the corners.  So I decided to try the create room polyline tool but there is no option to make a ramp out of it. I hate to keep monkeying with the plan as every little change causes the program to go wonkers and delete or change something else. 

 

 

           

                

ADDITION TO PLC (2).zip

[Renerabbitt]

1 hour ago, Evolution said:

So I decided to try the create room polyline tool but there is no option to make a ramp out of it. I hate to keep monkeying with the plan as every little change causes the program to go wonkers and delete or change something else.

[Evolution]

17 minutes ago, Renerabbitt said:

 

 

[Evolution]

26 minutes ago, Renerabbitt said:

 

Rene, I selected the polyline from room (I had already made) converted to a solid. Set the thickness, then selected it and attempted to drag one corner (from a section view of the polyline) down but it doesn't work for me.  I watched your video several times (I thought I was doing it the same way) but to no avail.) I may just have to leave it as is and pretend the holes are filled. Every time I make another attempt at it something else goes haywire and causing more grief than it's worth. 

 

Edited 7 hours ago by Evolution

[Evolution]

45 minutes ago, Evolution said:

Rene, I selected the polyline from room (I had already made) converted to a solid. Set the thickness, then selected it and attempted to drag one corner (from a section view of the polyline) down but it doesn't work for me.  I watched your video several times (I thought I was doing it the same way) but to no avail.) I may just have to leave it as is and pretend the holes are filled. Every time I make another attempt at it something else goes haywire and causing more grief than it's worth. 

 

 

Well, I took the coward's way out I guess and created a polyline solid for each hole, change material to the carpet, set the height and solved my own problem. Not the way Rene did it, but I couldn't get your way to work for me Rene. 

 

 

 

 

  

[Renerabbitt]

19 minutes ago, Evolution said:

Rene did it, but I couldn't get your way to work for me Rene. 

is your signature up to date? I might make it more clear that you are on X12 if that's the case