BenReece Posted December 7, 2020 Share Posted December 7, 2020 It's me again! My client would like to have an angled kitchen peninsula (as pictured). Trying to figure out the easiest way to make this happen. I have not found a way to manipulate a cabinet to do what I would like it to. Would this be a situation where I would need to create a custom symbol? Anyone have any experiencing with similar cabinet work? Thank you. Link to comment Share on other sites More sharing options...
Alaskan_Son Posted December 7, 2020 Share Posted December 7, 2020 Those types of configurations are typically built like this... ...and if you make sure that Create Automatic Fillers for Angled Connected Cabinets is check under your General Cabinet Defaults, then that area will automatically close up too. 1 2 Link to comment Share on other sites More sharing options...
BenReece Posted December 7, 2020 Author Share Posted December 7, 2020 I tried that but I guess I was not putting in the right numbers! Thanks again! Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now