BenReece 0 Posted December 7, 2020 It's me again! My client would like to have an angled kitchen peninsula (as pictured). Trying to figure out the easiest way to make this happen. I have not found a way to manipulate a cabinet to do what I would like it to. Would this be a situation where I would need to create a custom symbol? Anyone have any experiencing with similar cabinet work? Thank you. Share this post Link to post Share on other sites
Alaskan_Son 2536 Posted December 7, 2020 Those types of configurations are typically built like this... ...and if you make sure that Create Automatic Fillers for Angled Connected Cabinets is check under your General Cabinet Defaults, then that area will automatically close up too. 1 2 Share this post Link to post Share on other sites
BenReece 0 Posted December 7, 2020 I tried that but I guess I was not putting in the right numbers! Thanks again! Share this post Link to post Share on other sites
