Most OnlineNewest Member
OK...I've been messing around with the "Tray Ceiling" tool in X12. Cannot for the life of me figure out how to create a "nested" tray ceiling. In the help file it shows to unique icons...one for a "tray"...and one for a "nested tray". I cannot find where this "nested" tray menu or icon exists.
Is the nested ceiling shown below in Example B possible with the Nested Tray Ceiling tool? Thanks!
Hello guys. I made a custom symbols and model for my electrical because CA dont have it.
I managed to make it but the problem is they cannot stay side by side.. they will merge like this
Btw the can stay side by side if each of em not the same height
How do i solve this? Please help
I have created a column out of Polyline solids and moldings. Is there any way to get an outlet to place into this surface? If there is not a way, what are your suggestions on what I do? It is a dummy column framed out that surrounds a steel post, there is plenty of room for an outlet to be placed within the open interior space. How do I place the outlet without there being a wall or a cabinet in this location? Please see the attached image. The red arrow points to where I would like to place an outlet.
Thank you for your help!
I am trying to draw suspended ceilings for my office area and having a problem with the suspended ceiling not starting a new grid alignment between some offices in 3D view. I want each office to have it own ceiling grid layout so I don't end up with small edges and misaligned ceiling tile and lights. It works between some rooms but not others. Here is what I do...I use "Draw Line" to layout my ceiling pattern, then I place my recessed lights where I want them, I go into "Room Specifications" -> "Materials" -> "Ceiling Finish" and select "Square Ceiling Tile." After all that, I go to camera view...I then use "Adjust Material Definition" and select the ceiling. On the "Pattern" tab and the "Texture" tabs I change the "Horizontal Offset" and "Vertical Offset" to match the lights. In some cases this works fine and other times the Horizontal Offset and the Vertical Offset don't stop and the interior walls and they adjust the ceiling on the other side of the wall (in the next office.) I can't figure out what I am doing differently that causes it to work properly some times and not others. Any help will be greatly appreciated. Thank you, David-R