salexander71

Close in Stairs above but leave open below?

Recommended Posts

Hello Everyone,

 

I have a dilemma that I can't seem to find an answer to. I an trying to close in a stairwell from above but leave the area underneath it open. I am stumped. 

The picture below shows what I am trying to do.

 

salexander71

Stair Issue.png

Share this post


Link to post
Share on other sites

Unfortunately Chief has nothing automatically to fix that error in programming, you must fix it using a p-solid , there are other ways to do it but this is the easiest.

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now

  • Member Statistics

    27469
    Total Members
    6254
    Most Online
    THDesign
    Newest Member
    THDesign
    Joined
  • Similar Content

    • By Designer100
      Hey guys,
       
      I ariginally had cable rails and now I cannot get stairs to go back to noarmal stairs. Ballusters are not showing and I need to deleter the cable rails that are showing up in specs. Stairs has been move from another part of floor plans. Proably something simple.
       
       
      Can someone help?
       
      Thanks for any help. 

      Richie_house._La_OPT._2_02_17.2020.zip
    • By KirkHodgson
      I'm looking to make my retaing wall larger than the terrain heights.
      In the instructions in this page, https://www.chiefarchitect.com/support/article/KB-00652/changing-the-height-of-a-retaining-wall.html
      I did all the steps, but the last point. In section/elevation, when I try to click the retaining walls, nothing happens. I don't get boxes or any selection at all.
      What is happening that I can't make this selection?
      I want to make my wall 6" above the grade/terrain elevation, and I want to drop the foundation of the wall by 24". How do I do this?
       
      Please assist.
      Thank you.
       

    • By MRMChief
      Happy Holidays everyone.
       
      I have a plan where I have a few places I need an exterior wall above a roof section, but a railing, or in one case, no wall below.  Is there a way to do this in Chief Architect X11?  The one opening in my screen shot shows some exterior molding, but no wall.  On the one that has the railing below it, I tried the lower wall type if split by roof, but I couldn't get it to show as a wall above and a railing below.  It was either only a railing or all wall.
       
      I am on a macbook pro..
       
      Thanks,

      Michael


    • By mprovost129
      Hi all. I'm fairly new to the software and have only been using it since October. I have a client who wants a wood framed chimney extruding from the middle of the roof up from the gas fireplace. I've tried a bunch of different options to make this work but can't figure it out. Can someone please tell me how to draw walls on top of the roof?
       
      Thank you!
       

    • By Designer100
      In 3d there is a wall sticking out. see jpeg attached. I cannot figure it out to remove.
      NEW-William_Dowdell_Dr.plan