No1ZZTopfan

Hanging Cabinet Door w/Rollers & Track Bar

Recommended Posts

Until the suggestion for one is added to an upgrade or next version of CA I decided to make a crude close facsimile of one. Attached are two hardware fixtures for you to use, modify, improve, etc. I have also attached and example that I made on the front of an entertainment center. Three wall cabinets were used on top of three regular base cabinets. On each wall cabinet, open the specification settings, go to Front/Sides/Back and modify #1 Separation from 3/4" to 4". That gives enough space for above and below for the roller. Position the bar in the center of this spacing. Guide Bar is 2" x 7/16". I did not add mounting brackets so it would allow for stretching and not cause issues. Hope you like.

 

Cabinet Roller Guide Bar.calibz

Cabinet Roller.calibz

example 2.jpg

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now

  • Member Statistics

    27600
    Total Members
    6254
    Most Online
    TitanRES
    Newest Member
    TitanRES
    Joined
  • Similar Content

    • By SMC2992
      Hi friends
      I want to draw a door to a strong room which has 2 single shutters, one opening inside of the room and second out side to the room. the wall is 12"thick.
      How i can achieve this?
      thanks
       
      Salahuddin
    • By VisualJoy
      Good afternoon,
      I am trying to design a kitchen but am having issues with both lower and upper cabinets that are convex.  I understand using the different door styles for the front, but how do I make the back of the cabinets fit?
    • By Renerabbitt
      After Photo
    • By nancyscial
      I am trying to show a recessed wall cabinet bottom for inserting a light strip. 
      I need to be able to show the bottom of the cabinet recessed up by 1 1/2" with the sides still down. The doors should cover the recess also.