Most OnlineNewest Member
Open to new work. I've been working remotely for clients for years and can easily navigate the issues that present themselves from remote work. I have plenty of references and videos demonstrating my various services. The following images are snippets from my site at www.RabbittDesign.net
I offer training-while-drafting services in Chief Architect as well as training in Sketchup, Thea Render, Photoshop, Premiere Pro and Procreate.
I tend to cater to experienced designers and drafters in Chief Architect, many of which benefit from and are quite pleased with anno/layer sets, library items, toolbars, and a more cohesive folder structure and .plan and .layout files.
A few hours of my service may cut hours off of every project you have going forward.
Feel free to check out my YouTube channel dedicated to all things drafting, designing, modeling and rendering in my signature below.
Take a look at some of my recent design work in the Gallery
Also, take a look at the extensive Free Content Thread and continued free content YouTube Series:
I've looked for a thread on this topic but cannot find one. Typical construction is CMU stem wall on footing and slab.
I would like to show outside edge of foundation block and all thickened slab areas (for bearing walls and posts). I see the foundation block on floor "0" and the thickened slab (under bearing walls) and post footings on floor "1". I would like to display all this on one layout and add dimensions for concrete, plumbing, and other under-slab work.
What is the best way to do this without redrawing a separate plan to accommodate these items?
Is there a room dialog to prevent this from happening? Ideally I want to make the cantilever a "cantilever" room and have it not generate walls under the cantilever with auto rebuild foundation walls on. Unless there is an easier way? Copying the balcony room settings ends up generating walls like the attached picture, still generating walls under cantilever. Feel like I'm missing something very simple.