rockyshepheard

I made bottom like poney wall. still not smooth.

I will try that and show video.

I am aware of the stone and the yellow wall type. But aside from that, how did you do it?

better visually Recording #1.mp4

ScreenRecorderProject2.mp4

I will make video.

That is bizarre. They are NEVER aligned when I make them. That's why I use them.

Can you do that on this face in my file? windows doors terrain.plan

Still getting this. I need to figure out hoe to record my procedure so I can post it.

It works as you say. I will try to reproduce and respond. Thx

How could they line up perfectly? The very definition of a pony wall is that it sticks out a certain distance. I absolutely must be missing something here.

Yes, I did that. Here is result.

Would you be so kind as to provide a 2D plan exemplifying what you say? Thanks

Interesting. What does this look like in plan view? I am not good enough at CA to take a drawing where the two floors are aligned an offset them to obtain this effect. I assume these two floors are not aligned, yes?

X11. Imagine you have two floors and you want a pony wall to go from ground level to the middle of the second floor. Above that is non-pony wall. If the walls in the plan view are aligned perfectly and you only put pony wall on second floor, you would have a pony wall sticking a few inches out over the first floor wall. The wall has to be smooth all the way up to the top of the pony wall. If you're thinking"Well, just make your walls non aligned and put regular wall on first floor, I cannot because I'm following the 2D ACAD file the architect gave to me. I hope you see my point.

My question is why won't "stop at ceiling above" do the trick?

I see, but if the first floor is masonry wall, won' the second floor with pony wall stick out (cantilever wise)over the masonry wall? The first and second floors should be continuous face with not inset or outset.

same topic

This is what I'm trying to achieve but it is too difficult for me. I'm overwhelmed.

I don't know how to clean up this one corner. Not sure if it is because of over definition of wall. Is someone willing to do it in the file for me? File is attached above.

Ahh! I will try. Thx

I have only one wall selected but the blue L doesn't show up. Try it to see. windows doors terrain.plan

Oh, that doesn't show up in toolbar when I select wall. I have Premier 11