BigKahuna Posted March 25, 2016 Share Posted March 25, 2016 I am using a half wall / pony wall of stone and as usual would like to add a stone cap to it. While I wish Chief would add a cap dialogue box for this where it would allow you to check box for cap and allow you to selct a moulding profile I cant see that this is the case. I have had to add it as a 3d polyline or moulding attached to the exterior in past but I havent done it in a while . What are best ways to achieve this ? I tried adding a molding on the room and offsetting out but that doesn't work. I cant attach a molding on the wall covering using exterior. Once it is achieved is it possible to save that wall type with a cap as new wall type ? Thanks for any help. Link to comment Share on other sites More sharing options...
Alaskan_Son Posted March 25, 2016 Share Posted March 25, 2016 Click on exterior room, make room molding polyline, set height, open moulding polyline, set desired molding, uncheck "Extrude Inside Polyline", and then break/modify polyline and suppress moldings as necessary. Link to comment Share on other sites More sharing options...
BigKahuna Posted March 26, 2016 Author Share Posted March 26, 2016 Thanks I finally also found the video again on the room molding polyline. So that worked. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now