I'm a relatively new user and am working my way through the Bachelor View project after the Chic Cottage project disappeared. I'm at video 6, "Creating Rooms and Defining the Ceilings" but I noticed something funky going on with some of my walls from the foundation/basement showing up on the first floor. I'm sure part of the issue is that some of my wall heights/foundation/stem walls are off, but the videos don't show what my defaults should be set to. Any advice would be greatly appreciated!
I have two different wall types here for a basement plan I'm working on. One is an 8" concrete stem wall with a 1 1/2" air gap, 3 1/2" framing, and 1/2" drywall. The other is a standard interior 6 wall. I can't seem to get them to play nice in the areas that they merge. Any help?
currently as shown the picture i have old plan which is using metric units, then i start drawing a exterior wall, and its show me wall types (SIDING 6), but when i get a new plan & repeat drawing a exterior wall, then i dont have wall types (siding-6) ? what was wrong > i have reset everythings...
I've had a few questions about some of my screen porch videos because I skipped over some of the basics. Here's a video that shows how to create a screen porch room...define the wall type and the railing wall type. I use "panels"...so, you will have to create a railing panel. I have also created a video on how to make a panel...it's on my YouTube Page. Let me know if I've missed something...or, if a guru has a tip or better method feel free to comment.
Very new user here, so please bear with me.
Using X9 on a 64 bit Windows desktop, just recently installed.
My 'normal' drawing formats show existing walls with just two solid lines (Unfilled), demo'd walls with two dashed lines (Unfilled) and all new walls have "poche" or hatch pattern(s) within the two solid lines (filled) depending on their type. [Typically 2D plans]
Is there any way to set up wall types or whatever to print this way? Usually plot in B/W or greyscale only, so existing wall hatch 'colors' don't help.
I don't mind if the existing walls look identical to new walls in the camera and ortho views, but for printing an existing and/or demolition plan I'd like it to show this way.