Can't Dimension To The Edge Of The Framing

[LynnBuilders]

I am trying to set my dimension at the edge of the framing, as shown in the attached picture. However, Chief seems to be adding a small section of wall that I can't select and it putting a break in one of the walls that I can select. When I extend both of the walls selected in the picture, the break goes away. When I bring the walls back to where they need to be, the break comes back. A dimension that was in place before the issue showed up is still in the right place, but I can't place my new dimension in the same place as that one (it just keeps snapping to the automatically added break). How can I fix this?

 

Thanks

[rlackore]

Are the wall types identical? Did you try using the Join Walls tool? Have you tried defining the problem wall as Through Wall at Start or Through Wall at End? I'm just spit-balling.

[LynnBuilders]

I am pretty sure that both wall types were the same, but I changed them both to something different (well, different "wall type" but same composition) and that fixed the problem. Thank you!