Can't Dimension To The Edge Of The Framing


LynnBuilders
 Share

Recommended Posts

I am trying to set my dimension at the edge of the framing, as shown in the attached picture. However, Chief seems to be adding a small section of wall that I can't select and it putting a break in one of the walls that I can select. When I extend both of the walls selected in the picture, the break goes away. When I bring the walls back to where they need to be, the break comes back. A dimension that was in place before the issue showed up is still in the right place, but I can't place my new dimension in the same place as that one (it just keeps snapping to the automatically added break). How can I fix this?

 

Thanks

post-1412-0-05692500-1407769568_thumb.jpg

post-1412-0-46789600-1407769670_thumb.jpg

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share