Migaloo

Thanks everyone for the help. I will try adjusting the color of the mortar joint.

Seems I have an issue with the brick pattern on exterior walls and foundation walls only displaying on the front and rear walls and not the side walls. Anyone else seen this?

Connie and James plan.plan

Thank you. That was very simple.

Too big to email too. I deleted some detail to get it a little smaller.

reference floor issue.plan

I have tried to upload but the file is too big to upload.

The doors, windows and stairs all display in red like they should. The walls display in black but are set to display in red. Apparently something is overriding this setting.

yes everything in the reference display options is set to red.

Anyone know why my reference floor display would show walls in black instead of red? Everything in the reference floor display options is set to display in red but the walls display in black on this particular plan.

That got rid of most of them but I have two that remain.

Thank you.

Just upgraded to X8 and now I have these boxes around each view sent to the layout page.

How do I turn this feature off?

Yes you are right. I just found that arc markers was checked on default cad settings. Thanks!

_{Yes. When I select it from the library it does not show the X's but once I place it on the plan they appear.}

I tried that too. I just drew a cad circle and noticed that it has an x in the middle of the circle that I cannot select to delete. Strange stuff here.

I can't select them. I selected the anchor straight out of the library and this is how they appear. Also my cad blocks with the anchors in them have the X marks on them also. Can't get rid of them.

What is making these X marks on this anchor bolt? How do I get them off?

ok I will play around with it some more. I think I will try rebuilding them first. Thank you for you advice.

 Maybe I should ask a different question:  In this plan I am attempting to show the brick ledge extending below the lowest floor level. As the front of the house is elevated for steps up to porch area and the rear porch is16" lower as it steps out of the sunken living room. I have been playing around with the stem wall trying to make this happen so that in my elevation views the brick exterior will extend below the floor level in order to cover the areas not covered by the terrain. I hope I have made sense here. I think maybe there is a better way to do this than what I have done.

ok I will play around with it some more. I think I will try rebuilding them first. Thank you for you advice.

Anyone know what the issue might be?

Ok I think I did it.

allentana.plan

I understand. Not sure how to attach the plan?

I have an issue with the foundation views of the same foundation wall not being the same. The garage view has more layers in the view. It appears to show footing and brick layer. The house view only shows outer wall and inner footing layer. I have been unable to see any difference in the settings that might cause this. The wall is a 8" concrete stem wall 4" brick ledge. Any ideas what is happening here? 

Thank you rosco2017. Not sure how it got assigned to that room specifically but that's what the issue was.

I can't figure out what is making this band around this room. The floor is sunken 12" from rest of house. No moldings are turned on. Can't select the line individually but you can use the eyedropper to change the material finish. Any thoughts?

Ok. Thank you for all of your help.