Wall Does Not Snap To Stairs?

[MAINEWOOD59]

The wall on the left side of the stairs does not "stop" at the stairs when I move it?

 

 

Cape (Stackpole rd.chief ).plan

[Bill_Emery]

It works for me.   I opened your plan, dragged the wall to the left, then brought it back into place, and it snapped as expected.  You may want to check your bumping and pushing settings.

[WendyatArtform]

Walls don't aways bump into stairs.  Stairs will bump into walls, but not always the reverse.  But they will snap to them.  Alt-Q to turn your "resize about" for walls to the surface.  Then drag and snap that to the stair.

[Bill_Emery]

I'll make a note to remember alt Q.  It seems like there is always more to learn.  I have a list of about 200 hotkeys that I'm learning, I'll add it to the list.

 

Point to point move is a reliable way to get the wall in place too.

[MAINEWOOD59]

Thanks, Wendy.  I never had to deal with this in my old program "9.5" ?

[WendyatArtform]

9.5 was before they introduced the "bumping/pushing" setting - basically everything bumped or pushed whether you wanted it to or not.  Having the bumping/pushing setting is very handy, but does take some adjustment.  It would make sense to me that with Bump/Push on that a wall would bump into a stair.

 

In my test with a new profile plan, it does, but just barely.  It's a bump that pushes through pretty easily, where other things sometimes more firmly resist.  My test on an old plan didn't bump at all, so there could be some difference with legacy plans.

 

At any rate, as long as your grab handle is on the surface of your wall, snapping works reliably.