ChiefTesoroTX Posted yesterday at 06:46 PM Share Posted yesterday at 06:46 PM When pulling moldings as 3D pipes, every so often I get a glitchy bend. I've not been able to figure out how to repair them without deleting and redrawing. Is there a quick trick to reset these bizarre angles? Link to comment Share on other sites More sharing options...
rwdozier Posted yesterday at 07:38 PM Share Posted yesterday at 07:38 PM I am curious as well. I do this for now by adding a short length at 45° to the other and just overlap them to make it a somewhat clean 90°. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now