Weird room foundation outline keeps coming back after I "fix" it. Help Please!

[Troywj]

This weird foundation outline keeps coming back and I don't know why. Any help would be greatly appreciated. When I click on it, it says it's a room.  

In the specifications it shows this

And this is structure.

After I change all the values to what it's supposed to be it looks right but then as soon as I do anything in the file it reverts back to these same settings. Any ideas?

 

Chief Architect Premier X16

[javatom]

Your rough ceiling default is 207".  That is causing everything to drop down.  Change it so the ceiling is correct.  It looks like you are going for a 9' ceiling.

[Troywj]

Thank you for the reply! Yes, it does show that in the screenshot. After I change all those values to what they are supposed to be everything looks correct and good. However, if I do anything in the file it all reverts back to these same settings with that same weird thing. I can't find what is causing this to happen.

[javatom]

Your floor defaults might be set wrong.  Check the ceiling settings for level 0 defaults.  It could be trying to reset it to what is shown there.

[Troywj]

Defaults all seem to be set correctly. I've attached the plan file if someone can figure this out. Or I can try contacting CA support. I guess the file is too big to attach so here's a link to it.

 

[LCDesigns]

Look at your stem wall height vs your ceiling height.

[Troywj]

Never mind. I had to change all the furred walls in the basement to actual furred walls then it fixe it. Thanks for the help!