Chief Architect and Window 10 upgrade

Clare_White

By Clare_White,
in General Q & A

 Share

Recommended Posts

Clare_White

Clare_White

Posted
Posted

Has anybody run the windows 10 update and now Chief Architect X9 and X10 I can't get any cameras to run. Camera elevation, perspectives, even old saved cameras. The floor plan seems to be the only window that will activate no multiple windows available.

 

Hate Windows it is a control freak.

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share
Go to topic listing

  • Member Statistics

    32939
    Total Members
    9156
    Most Online
    DavidRC
    Newest Member
    DavidRC
    Joined

  • Similar Content

    • creatrix
      Imported PDF
      By creatrix
      I have dragged a PDF of a rug to my elevation but as you can see, I'm not able to have the rug show up on the wall. What do I need to do?

    • creatrix
      4 Way Elevation Marker
      By creatrix
      How would I make one marker such as the one I've shown below? This is for a shower and there's just not that much room for 4.

    • Paradisaic
      Coloured Elevation Issues
      By Paradisaic
      Hello,
       
      I've been having ongoing issues with coloured elevations once it has been sent to layout. I always get these white dashes throughout the elevation image and I have no idea how to fix this problem. I've attached an image. 
      This is my settings when I send to layout:
       
      Send Options: Entire Plan/View
      Camera View Options: Plot Lines, (Colour Fill, Edge Line Defaults, Pattern Line Defaults all checked)
      Scaling: 1/2" = 1'-0"

    • TrimbachDesign
      Stepped foundation detail, sloping site
      By TrimbachDesign
      Hello Chief friends,
       
      I've been struggling and searching this topic but cannot seem to come up with the information that I am looking for. Basically, I have a sloping site and want to draw the uphill stemwall (top) 2'0" higher than the downhill wall. The floor system will ledger off the uphill wall, and the uphill stemwall top should finish about 2'0" higher than subfloor elevation. Wood wall framing will then be 2'0" shorter on this uphill side. Additionally, I'll be using some retaining walls extending off of the foundation to retain the up hill fill material. 
       
      I was able to "drag up" the top of the stem walls on the uphill wall to gain this two feet of elevation. However, there are all sorts of issues with wall intersections that I cannot seem to clean up. I think that what I am after is forcing the taller wall to run through, but I can't seem to force that in my foundation drawing or 3d view. There has to be a better way... Also, now the subfloor and some trim is sticking through the stem wall. 
       
      I'm running x12 on MacOSX. 
       
      Appreciate any help you all can provide! 
       
      Thanks,
      Austin

    • woodcraftdesign
      camera views in layout to big
      By woodcraftdesign
      using live camera views in layout, how do I change the size of these in the layout sheet.  I would like my renderings to measure 12" wide but I cannot change the size. Probly just an oversight on my part.