Flush Inside Returns on Fridge cabinet

[MarkMc]

I do a lot of cabinets that need a flush inside return in the opening of a fridge cabinet.

I was talking with Kelly on a thread in suggestions and while working on something she was looking for I thought I might use something similar to solve this issue.

So after a little smacking things around I have something that is respectable. The returns are not quite flush-set in 1/64" which is all I can get (let me know if you can do better)

Attached is a plan with flush returns on an inset cabinet along with the symbols used.

NOTE-

For overlay cabinets the symbol origins likely have to change, I haven't messed with those yet they might be easier.

Also note that for shorter openings than shown it is a good create a new symbol closer just taller than the opening with the vertical stretch plane set higher than the symbol (As I've done with these which are for an 84" opening)

I tried to use these same tricks to get extended sides but have not had success yet. Will work on it.