JosephSchloss

Hello, Thanks for taking the time to review my Post. I'm attaching the Plan here, It's drawn on x11 For Problem 1. Open the Plan & generate a 3D you will see the Issue right away. For Problem 2. I know I need a Wall break and that's what I actually did, but when starting to Drag up that broken wall segment, the system automatically reconnected all segments of the Wall into one. Pls review. Thanks in advance for your time and will to help!!! Hope you come up with a solution! Pls note; I'm with CA from 2017 x8 so don't hesitate to get into decaled commands. Wishing you all the Best. 220 for Post.plan

Hello everybody, Can anyone help out? This is a full height Basement (Floor Level is -94") with one room being even Lower (Floor Level -154") Two Problems: 1. I couldn't delete that wrap around under the full Basement. 2. That wall shown here on the right of the Picture needs to be stepped butt he system will either lower or raise the whole wall and will not allow me to step as required. Thanking in advance for any suggestion/help/etc.

While I'm Drawing a Structure that will have an 8' Basement + 2 full Stories, but the Bottom of the Foundation will only be 3.5 below Grade and the 1st floor will be raised accordingly, See Photo Attached (Typical Raised Colonial) the System would not allow me to raise 1st floor height from 0" only on a per Room Basis. but than When I do the Elevations it's Totally off, Any way to raise 1st floor Platform or any Other Solution to this Issue?

While I'm Drawing a Structure that will have an 8' Basement + 2 full Stories but the Bottom of the Foundation will only be -3.5 below Grade and the 1st floor will be raised accordingly, See Photo Attached (Typical Raised Colonial) the System would not allow me to raise 1st floor height from 0" only on a per Room Basis. but than When I do the Elevations it's Totally off, Any way to raise 1st floor Platform or any Other Solution to this Issue?