SeaGlassHomes

Got it!!! Thanks Charles & DB!! I did get to that dialog box but I did not notice the ability to change the reference at the "automatic" box choice.

Hello All, At one time you could change the red reference plan to a different plan than the one immediately above or below it. For example if you're on the 1st floor and go to foundation, select "reference floor" the reference floor in red is the 1st floor. At one time you could change that to 2nd floor while on the foundation. Did we lose it or is it a different dance I'm unaware of? Thanks.

How specifically do you import a layer set or plan view set in X17? There isn't much on the forum about it and I can't find anything in the help section. Thanks.

Hello All. I am located in the south coast of Massachusetts. I have extensive design experience as well as structural design experience. My plans are very thorough as I size all beams, joists, headers, posts and steel. I provide all beam reports and label the plans with each size / type etc. I will work for homeowners but my forte and preference is to provide plans to builders. I have been providing plans for builders for almost 30 years. If you want to connect reach out. Jay M. (508) 972-5127

I'm dredging up this old thread..... I have an HP T210 I've had for a few years and all WAS well until the last few months. I did update the driver to the latest yet I can't under any setting get it to print an 18" x 24" C size drawing. It will always print it to 24" x 24" so I have to trim off 6" from the top. Anyone else have this and fixed it recently? Thanks.