Joshlapp95

3D Warehouse was a no go. top hinge cabinet accomplishes what I need for a different kind of Hanger door. Thanks,

Hello, I am needing to draw a by folding Airplane Hanger door. The ones that hinge at the top and have two halves ( Splice running horizontally ) I am not able to figure out how to create the door with the hinge side on the top. any suggestions? Using X15 Thanks,

Ok, that makes sense now. Thanks.

How did you get the shape of that bottom window? I am not able to get the bottom side of the triangle. Thanks,

I am not finding this to work, as it does not allow me to adjust the wall cut out poly line. The other issue is, there is not frame, and it does not insert all the way through the wall, unless I set the glass to sit, on the inside finish layer. Thanks,

Thank you! I’ll give that a try!

Ive Tried every method I know of to create a upside down triangle window, and I have not been able to find a way that works. I use X13.

Hi, I am trying to create a roof plane with no ceiling finishes, leaving it op up into the roof framing. for some reason I can't seam to find the right way to do this. Thanks,

Thank you! I was able to figure it out with that help!

I need to join those two stairs.

it works on a Deck, but I cannot figure out how to do it on a standard platform. I have a raised floor section in the house, the customer whats a 96" wide stairway with the stairs wrapping back to the platform at a 45 degree angle. this works fine on a deck where you have a corner to drag them to, but not other wise.

Can someone explain to me how to do wraparound stair case? the stairs are not on a deck, the customer wants them 96" wide, and then run back to the platform at a 45 degree angle. I cannot seem to find the way to join the stairs together at the 45.