Greetings.
I'm sure someone has addressed this, but cannot find anything listed.
I'm trying to print the roof from Plan View. However, the "lower" roof line is visible and should not be. I've attached a few views for your help.
Roof Line.pdf
Roof Veiw.pdf
Alaskan_Son,
I realize this is an older thread, but great information!!
Is there a way to modify/delete the library object button. I want to use another object, as well as another icon.
solver and Greg_NY61,
Thank you both for the suggestions!
I tried unchecking the layers and it did not remove what I was wanting. Therefore, a drew a box w/t a fill and masked what i wanted to hide.
Greetings!
When I use a camera view as an elevation, the foundation/footings are shown - see attached. I would like for these not to be shown.
Front Elevation.pdf
I tried searching the forum but was not able to find anything on how to "un" mull a window. I have a window that i need to remove the mull on and need help.
I confirmed the door is recessed.
However, I did not have the exterior casing working - I was using a poly line for the trim. I deleted the poly line and added the exterior casing. The right side is working (see photo). However, the left side is not showing the casing and has not changed (see photo). I've also attached the plan view for the entire length of the garage door opening.
I'm confused as to why in camera elevation the pony wall brick appears to protrude past the outside edge of the garage door. However, in plan view the pony wall brick stops where it should.
Greetings!
I'm sure this question has been answered. However, I have looked for the past 3 hours and cannot find an answer.
See attached photo. As you can see, the area above the garage (gable end) is open and I cannot figure how to close it. There is no wall underneath roof in this area.