dkmtek

Thanks, I just tried that, but, no, didn't work? Even after saving, closing, re-opening? Any other suggestions??

crown moulding not showing up on the inside of an exterior wall? I have created a new exterior wall (Dbl masonry w/fir strips), I have three layers (Int, Main, ext.), the walls line up with upper and lower walls, but, the crown does not show up on these walls?

Thanks for your feedback! I think I've figured it out? First off, I'm on a mac with X8. Second, I was trying to resize "Manufacture items"? (Not as program friendly). I've done everything you suggested, and it didn't work (On manufacture catalog items) but, it does seem to work on Chief items. Thanks again!

What is the size of a "Pixel"? How do I adjust the bumping distance? When I bump it moves in 1" increments? Can I make this smaller? How do I adjust this to fractional movements?

Thanks for getting back/responding to me. the file is too large. Here is the (zip file) foundation plan (ver X8). 22443 basement.plan.zip

Does anyone know how (or if) you can set and hold Top of foundation walls to an absolute setting for a room, area or the whole drawing? The garage ToF moves around when trying to set stem wall heights, and change ceiling heights in one room vs another? I have attached a photo. Also, trying to connect walls, the program changes other walls when they snap together? How can I get it to stop?

I am having trouble trying to draw (Auto roof generate) a gull wing roof. It shows the offset (Distance from top plate to be about 10' offset even though it says "0" in the description? Can (and is so, how) I draw a gull wing roof manually? And/or what am I doing wrong in trying to generate a gull wing roof?