AgChief Posted January 29, 2015 Share Posted January 29, 2015 The plan attached is an existing house that's been added onto several times, hence the double gable roof with the cricket in the flat valley. I'm having a problem with the 8:12 under-framed cathedral ceiling not cutting the gable wall for the 9:12 roof plane above the ceiling. When I uncheck "Roof Cuts Wall at Bottom" in the "Roof" tab of the Wall Spec DBX of this gable wall, CA cuts out the exterior frame wall over the cathedral clg. In both checked and unchecked conditions, CA still draws the gable wall below the ceiling in the living room. See attached pics and plan. Any help will be greatly appreciated! Thanks! Hines2015 - Existing.plan Link to comment Share on other sites More sharing options...
evergreen Posted January 30, 2015 Share Posted January 30, 2015 I aligned some of the roof planes in plan view. Then, in cross section view, selected the attic wall, cut where needed and shaped it to the roof line, at the same time pushing it up out from the interior ceiling line. There may be a more systematic approach over brut force, but that's my best. Link to comment Share on other sites More sharing options...
AgChief Posted January 30, 2015 Author Share Posted January 30, 2015 Thanks Mike! Brut force had come to mind, but not the kind you're talking about. I'll try this at the office tomorrow. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now