How to fix wall connections in off-angle corner walls to enable resizing the door

[ChiefUserJarmo]

Here's the issue I have - I have this weird corner case of walls with multiple angles. As shown in the image, the underlying CAD has a door and I just cannot resize the exterior door properly. I think it is because the walls on left and right just kind of run into the diagonal wall and block the resizing of the door. I tried editing wall intersections but that did not help. The side walls just snap back. Any ideas how to solve the issue? Right now CA allows me add a door with 339mm width, but I need 700mm width.

[ChiefUserJarmo]

Thanks Eric! 

 

I tried room dividers, but that did not help

 

I'll attach a plan.

 

Koidula 11 V1.2.plan 

[ChiefUserJarmo]

4 hours ago, solver said:

Try drawing Room Divider walls where the red lines are.

 

Finally got it working (in a way) with room dividers and changing the wall thickness. Not 100% accurate - but good enough.

 

Thanks again Eric, for pointing to right direction!

 

 

[ChiefUserJarmo]

and I found another workaround - create the perimeter with thin walls first, add doors and then convert the wall type to thick wall.