Sign in to follow this  
mountaineer

Wall dimensions

Recommended Posts

Ok, this might be a very basic question but.... here goes.

I need my foundation to be 1.5" less on all four sides than my main floor perimeter dimensions to accommodate siding over the top section of the foundation wall.  I can't just change the dimensions because it doesn't change equally on all four sides.

I know there is a way to add a -dimension but I haven't had success.  Also, if I push the wall manually it only allows me to move in 1" increments.  Is there a way to push the wall just 1/2"?  Any suggestions would be great.  Thanks in advance for any input.

Share this post


Link to post
Share on other sites

In the Wall Specification dialog, adjust which layer your foundation builds to.

 

Transform/Replicate will move in any increment you desire.

 

You may also adjust the snap grid to 1/2" increments, for example.

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

  • Member Statistics

    28857
    Total Members
    9156
    Most Online
    RandyVol
    Newest Member
    RandyVol
    Joined